CoolTerm - Auto Reconnect
Posted: Wed Mar 24, 2021 5:46 am
This is a wishful feature request...
TeraTerm will automatically reconnect when a com port reappears.
i.e.
- you disconnect a USB cable to serial device and CoolTerm/TeraTerm appropriately disconnect
- you reconnect the USB cable and TeraTerm reconnects, Coolterm Doesn't (Tested on TeraTerm v4.105)
- This happens a lot in development, especially with VCP serial ports like on STM32
(Virtual Com Port by code in STM32 is lost for a bit whenever STM32 resets)
I much prefer CooltTerm, so would be very happy if Auto-Reconnect could be added.
Paul
TeraTerm will automatically reconnect when a com port reappears.
i.e.
- you disconnect a USB cable to serial device and CoolTerm/TeraTerm appropriately disconnect
- you reconnect the USB cable and TeraTerm reconnects, Coolterm Doesn't (Tested on TeraTerm v4.105)
- This happens a lot in development, especially with VCP serial ports like on STM32
(Virtual Com Port by code in STM32 is lost for a bit whenever STM32 resets)
I much prefer CooltTerm, so would be very happy if Auto-Reconnect could be added.
Paul